Russell Hobbs RHST102, Инструкции и гарантия, Страница: 6 / 12

SwITcH ON
• Sit the iron on the heatproof stand on top of the base unit.
• Put the plug into the power socket (switch the socket on, if it’s switchable).
• Press and release the boiler switch, then the iron switch.
• The boiler and iron lights will glow.
• When the boiler is ready to generate steam (2-3 minutes), the steam ready light will glow.
• It’ll then cycle on and off as the boiler works to maintain the temperature.
• If the temperature control on the iron is set above room temperature, the thermostat light on
the iron will glow, to show that the soleplate is heating up.
• It’ll go out when the soleplate reaches the temperature set by the temperature control, then
cycle on and off, as the thermostat works to maintain the temperature.
PRIMING
• Prime the iron after filling the reservoir, to get water and steam through the system.
• Hold the iron below the level of the base unit, and press the steam button, on top of the iron.
• You’ll hear the pump as it pushes water through the system, then, after 30 seconds or so, it’ll
start to quieten, and steam will come out of the soleplate.
The iron is now primed and ready for use.
PREPaRaTION
• Check for textile care symbols ( ) on items to be ironed.
• Iron fabrics needing low temperatures first, then those that need
medium temperatures , and finish with those needing high
temperatures .
SET THE TEMPERaTURE
• Turn the temperature control to bring the setting you require next to
the mark.
TEMPERaTURE SETTING GUIDE
label marking temperature dot setting
cool - nylon, acrylics, polyester •
warm - wool, polyester mixtures • •
hot - cotton, linen/denim • • • / max
do not iron