6
26
W
ait till the thermostat light goes out, then start ironing.
27 Press the steam button for steam, release it to stop the steam.
,
Don’t let the water level drop below
min
while the iron is in use.
38 Don’t hold the steam button down for more than about 5 minutes.
39
W
hile you’re steaming, the display will put on an animated show.
,
Steam may still escape from the iron after the you release the
button. This is normal, don’t worry about it.
dry ironing
40 You can dry iron by just not pressing the steam button, but if you want to make sure
you don’t press it accidentally, then you should turn the steam generator off.
41 Press and release the
-
button till there’s no steam showing under the iron in the
display, and the
Q
(no steam) symbol comes on under the water hardness symbols..
vertical steaming
42 Remove wrinkles from hanging clothes, hanging curtains, and furnishing fabrics.
43 Check that there’s adequate ventilation behind the fabric, otherwise moisture may
build up, causing mildew.
44 Check that there’s nothing behind the fabric that may be damaged by the steam.
45 Check that pockets, turn-ups, and cuffs are empty.
46 Check that there’s water in the reservoir.
47 Check that the temperature control is at
S
or higher.
48 Use the
+
and
-
buttons to set the steam level you want.
49 Hold the iron close to (but not touching) the fabric.
,
Hold it well away for delicate fabrics, and use low steam.
50 Press the steam button to produce steam.
51 Don’t hold the steam button down for more than about 5 minutes.
,
Don’t let the water level drop below
min
while the iron is in use.
no water
52 If you do let the reservoir run out of water, the pump will start to get noisy.
53 Fill the reservoir (see “
filling
”, on page 4), then prime the iron again.
after use
54 Turn the temperature control to
•
.
55 Sit the iron on top of the base unit.
56 Press the
2
button to turn off the display and elements.
57 Unplug the base unit
58 Top up the reservoir
a) this’ll give you a head start next time you use the iron
b) it’ll help to avoid inadvertently running out of water
23 To set the steam level, press and release the
-
and
+
buttons at the right of the
display (take care not to press the central
2
button, or you’ll switch the iron off).
24 The default level is high steam, so start with the
-
button.
25 The display will change to show the steam level you’ve chosen:
,
,
