8
Positioning
•
This appliance is installed on the wall.
•
Avoid damaging the product during installation
•
The appliance can only be used safely if it is correctly installed according to the
safety instructions. The installer is responsible for ensuring that the appliance
works correct when installed.
•
The width of the extractor hood must correspond at least with the width of the
hob.
•
For the installation, observe the currently valid building regulations and the
regulations of the local electricity and gas suppliers.
•
When conveying the exhaust air, official and legal regulations (e.g. state
building regulations) must be followed.
•
The exhaust air must not be conveyed into a functioning smoke or exhaust gas
flue or into a shaft which is used to ventilate installation rooms that contain
heating appliances. If the exhaust air is to be conveyed into a non-functioning
smoke or exhaust gas flue, you must obtain the consent of the heating engineer
responsible.
•
Always ensure adequate fresh air in the room if the appliance is being operated
in exhaust air mode at the same time as room air-dependent heat-producing
appliance is being operated.
All measurements in the below diagram are in millimetres (mm)
