No steam is being produced
or leakage.
The temperature dial has been
set to
“0”/ “OFF”/ “MIN”
.
Set the temperature dial
to the required positioin.
No burst of steam or no
vertical steam.
The (vertical) burst of steam
function has been used too often
within a very short period.
The iron is not hot enough.
Continue ironing in a
horizontal position and
wait a few minutes before
using the (vertical) burst
of steam function again.
Leaking
water
from
soleplate.
Set the temperature dial so that it
is not within the steam range.
Set the temperature dial
as per steam range.
There is still not enough heat
being produced.
Use the steam button only
after the indicator light
has turned off.
The water is over the max
position.
Pour out the remaining
water.
Little Steam
Check if the steam knob is in the
correct position.
Set the steam knob to the
correct position.
A steam hole is blocked.
Clean the steam hole with
distilled water.
Too little water in the water tank.
Fill water into the tank as
per earlier instructions.
No Spraying
There is not enough pressure or
air inside.
Press the spray nozzle by
hand and push the spray
button
several
times
continuously.
SERVICING THE APPLIANCE
There are no user serviceable parts in this appliance. If the unit is not operating correctly,
please check the following:
•
You have followed the instructions correctly
•
That the unit has been wired correctly and that the wall socket is switched on.
•
That the mains power supply is ON.
•
That the plug is firmly in the mains socket.
