Russell Hobbs RHFP1000, Инструкции и гарантия

Страница: 6 / 20

MINI PROCESSOR BOWL
CAUTION: DO NOT handle by the blade. The blades are very sharp. Use caution when
handling and storing.
•
The mini processor bowl is operated when nestled inside of the large processing bowl.
It will sit at the top and also
•
Carefully lower the mini processor bowl over the centre post, making sure notches on
the outside rim of the mini processor bowl are aligned with the grooves on the large
processor bowl.
•
Hold the small blade by the plastic shaft and place over the centre post.
•
To remove the mini processor bowl, lift it carefully straight out of the large processor
bowl.
THE PROCESSOR BOWL LID
•
Place the processor bowl lid over processor bowl with the wide feed chute slightly
to the right of the handle.
•
Hold the bowl handle and rotate the lid clockwise until the lid locks into place. The
handle and the feed chute should now be aligned.
IMPORTANT: For your protection this appliance has an interlock system. The
processor will not operate unless the processor bowl, lid and feed chute are properly
aligned and locked into place.
FOOD PUSHER ASSEMBLY
•
Insert the small food pusher into the large food pusher.
•
The small food pusher can be locked into position in the large food pusher. Insert the
small food pusher into the large food pusher with the notch at the top of the large pusher
aligned with the opening of the groove on the top of the small pusher.
•
Using the tabs on the small food pusher rotate clockwise until it locks into place.
To unlock turn the small food pusher anti-clockwise.
•
Insert the large food pusher into the wide mouth feed chute.
•
The small food pusher can be removed when adding liquid or additional foods while the
processor is running. For added safety the processor motor will stop running when the
large food pusher is removed, it will recommence once the large food pusher has been
replaced into the feed chute.
NOTE: There is a locking switch on the outside of the feed chute for added safety.
Slide the switch to the left to lock. Slide the switch to the right to unlock.
•
To remove the processor bowl lid, turn anti-clockwise.
CONTROLS
•
The controls are located on the front of the base motor unit.
•
Make sure the control dial is set to the ‘OFF’ position.