32
Connection of the Water Supply & Drain Hose
Connection of the Water Supply
Important note: Before attaching the water inlet hose, run the water until it is perfectly
clear so that any impurities that may be present in the water do not clog the appliance. This
precaution is needed to avoid the risk of the water inlet getting blocked and damaging the
appliance.
Connect the water inlet hose to a threaded 3/4(inch) connector and make sure that it is
fastened tightly in place. The water inlet hose must be connected to a cold water supply.
Notes:
•
If the inlet hose is not long enough, contact a specialist store or an authorised technician.
•
The maximum permissible inlet water pressure is 1Mpa.
•
The minimum permissible inlet water pressure is 0.04Mpa.
•
The hose should not be bent or compressed.
•
The appliance must be connected to the water supply network using new hoses.
•
Do not use old hoses.
•
Ensure that the new hose supplied is connected and the old hose is disposed of safely.
•
DO NOT overtighten the hose connector, hand tight is sufficient.
•
Ensure the fill hose is not kinked.
•
DO NOT connect the dishwasher to a single outlet instantaneous water heater or an
electric heater.
Before First Use
Before the first use of the dishwasher after installation you must check for the following
points:
1. All packing materials and printings have been removed from the dishwasher
2. The dishwasher is level and fixed properly
3. The water inlet valve is open
4. There is no leakage at the connections water inlet hose and the water inlet valve or the
drain hose and the drain.
5. The inlet and drain hoses are knotted
6. The wires are tightly connected and not trapped
7. The power is switched on
