31
Connection of the Water Supply & Drain Hose
Important notes:
•
Connection to the water and electricity supplies should only be performed by a qualified
technician.
•
The dishwasher should not stand on top of the water hoses or the electricity supply
cable. The water inlet and outlet hoses and the electricity supply cable may be
positioned towards the right or the left in order to achieve the best possible installation.
Connection of the Drain hose
Important notes:
•
Before connecting the drain hose, remove any internal restrictions; this will prevent a
build up of debris which could cause a blockage remove any restrictions from the waste
spigot and ensure that the sealing bung is removed.
•
It MUST NOT be connected to a surface water drain.
•
Do Not connect the dishwasher to the drain with an extended drainage hose (use the
ones supplied with the appliance), if an extension hose is needed then a pump must be
installed to pump the drainage through and out.
Insert the drain hose into a drain pipe that has a minimum diameter of 4cm (40mm) making
sure to avoid bending or crimping it. Use the drain hose hook (accessory 13) that is supplied
with the appliance. The top of the hose must be at a height between 40cm/400mm (B on the
diagram) and 80cm/800mm (A on the diagram). The free end of the hose must not be
immersed in water to avoid the back flow of it.
•
Ensure the drain hose is securely attached, to prevent it coming away while the machine is
in use and causing a flood.
•
Fit the end drain hose that is connected to the waste pipe securely by using a “Jubilee”
type clip.
M
IN
4
0
0
mm
M
A
X
800m
m
