10
INSTALLATION
Selection of the installation equipment
Drill holes on the table surface according to the sizes shown in the drawing. For the purpose
of installation and use, a minimum of 50 mm space shall be preserved around the hole.
Be sure the thickness of the table surface is at least 30mm. Please select heat-resistant
table material to avoid larger deformation caused by the heat radiation from the hob.
Important
There must be a minimum distance of 100 mm between the hole
and the wall or adjoining cupboard. If the hob is more than 30
mm thick, or if it is placed on a false top, the ventilation cover
must be fitted as shown in the figure 1.
Placement
Your appliance could be installed above a drawer, a cupboard with door or an oven.
- To install your appliance above a drawer
The electronic circuits of the hob must be cooled by a
current of fresh air as shown in the diagram, and the points
below must be carefully complied with. The greater distance
between the hob and the cupboard underneath it, the better
the hob will function as shown in the figure 2.
Figure1
Important
:
Your hob needs an air inlet at the rear and an air outlet at the front.
Figure2
66
5 80
0
1
5
5 60
min 38
