Russell Hobbs 24440-56, Инструкция по эксплуатации

Страница: 4 / 96

4
BEFORE FIRST USE
• Remove any labels, stickers or packaging from the iron and soleplate.
• Before using the iron for the first time, or if it’s not been used for a long time, iron a scrap piece of
cotton (an old towel is ideal) to remove any accumulated residues.
• Don’t worry if the iron smokes a bit at first, it will soon stop as the manufacturing residues evaporate.
FILLING/REFILLING
You may use the iron with tap-water, but if you live in a hard water area, you should use distilled water (not
chemically descaled or softened water).
If you buy distilled water, check that it’s suitable for use in irons.
1. Remove the reservoir by pulling it away from the body of the steam generator using the grip on the
front of the reservoir .
2. Fill the reservoir to the
max
mark. Do not exceed the
max
mark.
3. Refit the reservoir into the base unit.
PRELIMINARY SETTINGS
1. Put the iron on top of the base unit.
2. Put the plug into the power socket (switch the socket on, if it’s switchable).
3. Turn the unit on by setting the on/off button to I .
4. Turn the temperature control to bring the setting you require next to the mark. The thermostat light
will flash until the iron has reached its desired temperature. Once the temperature has been reached
the light will remain on.
5. Use the steam control to select the amount of steam you want (
m
= low,
l
= medium,
h
= high).
TEMPERATURE SELECTION GUIDE
1. Check for textile care symbols (
i j k l
).
2. Iron fabrics needing low temperatures first, then those that need medium temperatures , and finish
with those needing high temperatures (or max).
3. Turn the temperature control to bring the setting you require next to the mark.
If the instructions on the fabric label differ from this guide, follow the instructions on the label.
L
abel marking Dot setting
j
cool – nylon, acrylics, polyester
•
k warm – wool, polyester mixtures • •
l
hot – cotton, linen
• • •
/ max
i do not iron
When the soleplate reaches operating temperature, the thermostat light will stay permanently on.
STEAM IRONING
1. If you intend to use steam, the temperature setting must be at l or higher.
2. Use the steam control to select the amount of steam you want (
m
= low,
l
= medium,
h
= high).
3. Squeeze the steam button to produce steam, release it to stop.
NOTE: When you first start your steam station and pull the trigger for steam ironing, there will be a
delay as your steam station pumps water from the reservoir to prime the system. This is normal
and may take 20-30 seconds. This will also happen after refilling the reservoir.