Russell Hobbs 18553, Инструкции и рецепты

Страница: 11 / 20

11
jug
b
lender
15 Don’t run the jug blender empty, it may overheat.
16 Don’t use the appliance if it’s damaged or malfunctions.
17 If the cable is damaged, return the appliance, to avoid hazard.
household use only
U BEFORE USING FOR THE FIRST TIME
Turn to “ care & maintenance ” on page 5, and clean the appliance and attachments thoroughly.
C POSITIONING
1 Sit the appliance on a water-resistant, dry, stable, level surface.
2 Route the cable so it doesn’t overhang, and can’t be tripped over or caught.
3 Fit the bowl and splash guard to the appliance, as the mixer drive operates when the motor is
running.
C USING THE JUG
4 Put a hand on top of the rear drive cover and twist anti-clockwise, to release it and expose
the drive for the jug.
5 Align the spout with the speed control.
6 Lower the jug on to the drive.
7 Turn the jug clockwise till the latches under the jug base engage with the drive, then push
down and keep turning till it locks into place.
C ADD THE INGREDIENTS
8 Put the ingredients into the jug.
9 Although the jug can measure up to 1.25 litres, you shouldn’t fill it past the 1.0 mark – if you
do, the contents may force the lid off at speed.
10 Put the lid on the jug, and push it down to secure it.
11 Don’t use the jug without fitting the lid:
a) the contents may escape
b) you may hurt someone
c) you may be tempted to put a hand into the jug
C POWER UP
12 Check that the speed control is set to 0.
13 Put the plug into the power socket (switch the socket on, if its switchable).
C SPEED CONTROL
14 Turn the speed control clockwise to the speed you want.
15 The range is from 1 (low) to 10 (high). Turn the speed control back to 0 to turn the motor off.
16 You’ll no doubt have your own preferences, but, generally, use low speeds for lighter
mixtures, and high speeds for heavier, thicker mixtures.
17 Don’t run the motor continuously for more than 10 minutes, it may overheat. After 10
minutes, switch off for at least 10 minutes, to let the motor recover.
18 Switch off, unplug the appliance, and wait till the motor stops before fitting or removing an
attachment, before dismantling, and before cleaning.
Y
PULSE
19 Turning the speed control anti-clockwise to
Y
will give you a short burst at high speed. In
this direction, the knob is spring-loaded. When you let go, it’ll return to 0.
20 Use
Y
as a “pulse” function, for more precise control.
a) turn the speed control to
Y
for a second or two, then release it
b) check the state of the ingredients
c) repeat, till the ingredients are exactly the consistency you want
21 Don’t run the motor continuously on
Y
for more than 1 minute, it may overheat. After 1
minute switch off for at least 2 minutes, to let it recover.