Russell Hobbs 14624, Инструкция по эксплуатации

Страница: 4 / 8

4
fitting the whisks/hooks
1 Switch off (0) before fitting or removing the whisks/hooks.
2 Align the pips on the shaft with the slots in the drive head.
3 Push the shaft into the drive head till it clicks into place.
4 Each whisk/hook must be fitted into a specific drive head.
5 The shaft with the flange fits the head with the large hole.
6 Use both whisks or both hooks, don’t mix them.
removing the whisks/hooks
7 Switch off (0) and unplug the mixer, then shake any excess
mixture into the mixing bowl.
8 Hold both whisks/hooks, to prevent them jumping out,
then press
5
to eject them from the drive heads.
speed switch
9 Move the switch to the right to switch on.
10 Choose a speed between 1 (low), and 5 (high).
11 Slide the switch fully left (0) to switch off.
the turbo button
Y
12 Slide the turbo button
Y
towards the rear of the mixer to
over-ride the speed switch, for a burst of high speed (5).
13 This only works when the motor is already running (1 to 4).
timings and speeds
14 If you’re using a recipe book, follow the recipe.
15 If you’ve no recipe, you’ll need to experiment to find the
best settings.
16 Timing and speed will vary with the amount, thickness,
and composition of the mix.
17 Generally, large quantities, thick mixes, and a high ratio of
solids to liquids suggest longer timings and slower speeds.
18 Smaller quantities, thinner mixes, and more liquids than
solids suggest shorter timings and higher speeds.