DIMensIonal DaTa
InsTallaTIon InsTRUCTIons
1) Mount the device in desired location (see step 1)
2) Open the lid and route cable through strain relief
and connect the wires to terminal block (see step 2).
3) The device is now ready for configuration
WARNING! Apply power after the device is properly
wired.
sTeP 1 MoUnTInG THe DeVICe
1) Select mounting location (duct, wall, panel) within
120 feet of the air measurement station.
2) Use the device as a template and mark the screw
holes, then drill holes.
3) Mount with appropriate screws (not included)
Figure 1
Figure 2
Figure 3B
Figure 3a - surface Mounting
strain
Relief
RUsKIn DPT-IQ FloW MeTeR WITH BaCKlIT DIsPlaY InsTallaTIon InsTRUCTIons
3
