20
RUSH Strobe CWL
TM
User Manual
Selecting trigger mode
Stand-alone routines can be automatically triggered or sound triggered.
To select trigger mode:
1. Press MENU to enter the control menu.
2. Select SOUND MODE and press ENTER to confirm.
3. Use the UP and DOWN buttons to select ON for sound trigger or OFF for
automatic trigger. Press ENTER to save the setting.
4. Press MENU to exit.
Adjusting sound trigger level
1. Press MENU to enter the control menu.
2. Select SOUND SENSE and press ENTER to confirm.
3. Play the sound source (music beat, for example) at a typical volume.
Press the UP button to increase microphone sensitivity or the DOWN
button to decrease sensitivity. When sound triggering is satisfactory, press
ENTER to save the setting.
4. Press MENU to exit.
Master/slave operation
Multiple fixtures can be operated in Show Mode without a controller using the
master/slave function. You can select any convenient fixture to be the master
fixture that controls the others. You set the remaining fixtures as slaves.
There are 4 slave mode options that allow you to create dynamic effects
among multiple fixtures. Fixtures set to SLAVE1 flash at the same time as the
master. Fixtures set to SLAVE2, SLAVE3, and SLAVE4 flash with a timing
delay that is determined by the show selection. SLAVE1 is the default setting.
You can connect up to 32 fixtures using DMX cable to connect one fixture’s
DMX OUT socket to the next fixture’s DMX IN socket. See ‘Control data link’
beginning on page 16 for more information about connecting fixtures.
To set up the master fixture:
1) On the fixture selected to be the master, press MENU to enter the control
menu.
2) Select MASTER/SLAVE. Press ENTER.
3) Press UP or DOWN to select MASTER. Press ENTER to save the setting.
4) Set the master fixture to run one of the stand-alone shows. See ‘Selecting
a Show Mode routine’ on page 19.
