Rush DC 1 Aqua, Руководство пользователя

Страница: 17 / 36

RUSH DC1 Aqua User Manual 17
Control data link
A DMX 512 data link is required in order to control the fixture via DMX or to
use the master/slave functionality. The fixture has 5-pin XLR connectors for
DMX data input and output.
The number of daisy-chained fixtures is limited by the number of DMX
channels required by the fixtures in relation to the maximum 512 channels
available in one DMX universe. Note that if independent control of a fixture is
required, it must have its own DMX channels. Fixtures that are required to
behave identically can share the same DMX address and channels. To add
more fixtures or groups of fixtures when the above limit is reached, add a DMX
universe and another daisy-chained link.
Tips for reliable data transmission
Use shielded twisted-pair cable designed for RS-485 devices: standard
microphone cable cannot transmit control data reliably over long runs. 24
AWG cable is suitable for runs up to 300 meters (1000 ft.). Heavier gauge
cable and/or an amplifier are recommended for longer runs. The pin-out on all
connectors is:
•
pin 1 = shield
•
pin 2 = cold (-)
•
pin 3 = hot (+)
Pins 4 and 5 in the XLR connectors are not used in the fixture but are available
for possible additional data signals as required by the DMX512-A standard.
Standard pin-out is:
•
pin 4 = data 2 cold (-)
•
pin 5 = data 2 hot (+).
To split the link into branches, use a splitter, such as the Martin 4-Channel
Opto-Isolated RS-485 Splitter/Amplifier. Terminate the link by installing a
termination plug in the output socket of the last fixture. The termination plug,
which is a male XLR plug with a 120 Ohm, 0.25 Watt resistor soldered
between pins 2 and 3, “soaks up” the control signal so it does not reflect and