Rush DC 1 Aqua, Руководство пользователя

Страница: 19 / 36

RUSH DC1 Aqua User Manual 19
To set the fixture’s DMX address:
1. In the control menu, select DMX ADDRESS and press ENTER to confirm.
The current address will blink in the display.
2. Use the UP and DOWN buttons to select the address (001 to 512).
3. Once the address has been selected, press ENTER to set it (or press
MENU to exit without saving any changes).
Standalone operation
The fixture can run a standalone light show without needing a DMX signal. 3
different pre-programmed standalone shows are available.
Show mode
To select which pre-programmed show a fixture runs in standalone mode:
1. Select SHOW MODE and press ENTER to confirm.
2. Use the DOWN and UP buttons to select SHOW 1 to SHOW 3 (pre-
programmed shows).
3. Press ENTER to set (or press MENU to exit without making a change).
Master/slave operation
Fixtures in standalone mode can be linked in a chain and set to master/slave
operation, where one master fixture running a standalone show controls the
behavior of slave fixtures. Two slave modes are available:
•
Fixtures in Slave 1 mode copy the master.
•
Fixtures in Slave 2 mode are synchronized with the master but have slight
variations in behavior.
You must set all the fixtures except one as slaves. If you set more than one
fixture in the chain to act as master, you may cause damage that is not
covered by the product warranty.
To run fixtures in master/slave operation:
1. In the Master/Slave menu, set one fixture to Master and set all the other
fixtures to Slave 1 or Slave 2.
2. Link fixtures in a chain, using DMX cable to connect one fixture’s DMX
OUT socket to the next fixture’s DMX IN socket.
3. Set the master fixture in the chain to run a standalone show using its
SHOW MODE menu (see ‘Show mode’ above).
4. Make sure that the fixtures are not receiving a DMX signal.