7
of the tool at maximum speed and without load for one minute, keeping at a safety distance.
If the
accessories are damaged, they will break during this test.
PARTS OF THE TOOL
STARTING UP
WARNING: To reduce the risk of injury, only the 18V Li-ION Battery Pack 9HB180LT (5) or the power
supply 9HP180LT (6) should be used with this product.
Since the batteries, other than those offered by RUPES, have not been tested with this product, use of such
batteries with this tool could cause the injury and property damage.
BATTERY PACK (PROVIDED OR OPTIONAL)
WARNING: For your personal safety, READ and UNDERSTAND the instruction manual of Battery
pack 9HB180LT before using.
WARNING: Avoid short circuiting the contacts. Avoid mechanical damage of the battery pack. Do not
open or disassemble. Advice on protection against fire and explosion. Keep away from open flames,
hot surfaces and sources of ignition.
Temperature in excess of 45°C reduce the performance of the battery pack. Avoid extended exposure to heat
or sunshine. Storage at room temperature (approx. 20°C) at approx. 20~60% of the nominal capacity. Every six
months of storage, charge the battery pack as normal.
Intended use
The battery pack 9HB180LT (5) is used as the power source for RUPES HLR75.
Battery pack specifications:
Model
Chemistry
Voltage
Capacity
Energy
Weight
9HB180LT Lithium Ion
18V
2.5 Ah
45 Wh
0.360±0.005 kg
WARNING: for other technical data refer to the label of Battery pack 9HB180LT.
WARNING: to reduce the risk of injury or explosion, never burn or incinerate a tool’s battery pack
even if it is damaged, dead or completely discharged. When burned, toxic fumes and materials are
created.
ASSEMBLE AND DISASSEMBLE BATTERY PACK
AWARNING: Before (dis)assembling the tool assure that the speed regulation Knob (2) is in OFF
position.
In order to assemble the battery pack, push the clip and insert the battery pack in the tool till it is fixed.
In order to disassemble push the clip and extract the battery from the tool.
CHARGE THE BATTERY PACK
WARNING: For your personal safety, READ and UNDERSTAND the instruction manual of
charging station 9HC180LT before using.
WARNING: Charge Rupes 18V Li-ION Battery pack 9HB180LT only in the Rupes 18V Li-ION Battery
Charger 9HC180LT. Other types of batteries may cause personal injury and damage. This tool’s
battery pack and charger are not compatible with NiCd or NiMH systems.
The battery pack(s) contained in the kit shall be charger before use. The provided battery is charged <30%.
In order to charge, connect the Li-Ion battery with a charging station 9HC180LT till the charging is completed.
Charge your battery tool when convenient for you and your job.
1 - Identification plate
2 - ON/OFF – Speed regulation knob
3 - START/STOP switch lever
4 - Backing pad
5 - Battery Pack 9HB180LT
6 - Power supply 9HP180LT
7 - Backing pad screw
8 - Allen wrench
