Runco WindowWall, Руководство по установке

Страница: 54 / 196

Installing LCD Tiles
40 Runco WindowWall Installation Guide
Installing Second and Subsequent Rows
1
Starting at the center display of the next row that you want to install, follow steps
1
-
9
of "Installing the First or Bottom Row" on page 33.
Caution: Depending on how the previous row was adjusted, when placing one display on
top of another display, be sure to avoid contact between the displays. Damage may occur
from the upper displays banging into or resting on the lower displays.
2
Verify that the position sensors are working by displaying the on-screen menus
on the LCD. The first LCD on the left in the row should always show the display ID
of 1:1. As you build the row out, the left of the two numbers on each LCD should
show an incremental number. As you build each column, the right of the two
numbers should be an incremental number. In the example below, you would
expect to see 1 in the far left LCD, 2 in the next one, etc. Each number must also
be unique. If you see a duplicate number or no information at all, check your
cabling to make sure everything is properly connected and all of your modules
are turned on.
3
Make sure the first display in the row is plumb with the display below it using the
x-axis adjuster.
4
Using the y-axis adjusters, set the horizontal gap between the displays at .38mm
(approximate thickness of a business card).
5
Adjust the z-axis corners of the last installed display until it is flush with the
display next to it. Depending on the adjusted corner, this may require that the
display be put in service mode. The alignment of the bottom corners might need
to be re-adjusted as each new display is installed in the row.
6
Repeat steps
1
-
5
of this section to install subsequent displays in this row.
7
When you are finished, check the wall one more time to make sure the display IDs
are in the correct order. See the example above as a reference.
1:1 2:1 3:1
1:2 2:2 3:2
1:3 2:3 3:3
Check the number on the left when building a row.
Check the
number on the
right when
building a
column.