Runco VX VIDEO XTREME VX-33D, Руководство по установке и эксплуатации

Страница: 81 / 94

Runco VX-33d Installation/Operation Manual 65
PRE
L
IMINAR
Y
6.1
RS-232 Connection
and Port Configuration To interface the DHD Controller with a home theater automation/control system or a PC
running terminal emulation software, connect it to your control system or PC as shown in
Figure 3-16.
Use a null-modem cable.
If you are using a PC to communicate with the DHD Controller:
1. Start a terminal session on your PC using a terminal-emulation program, such as
HyperTerminal.
2. Configure the PC serial port as follows: no parity, 8 data bits, 1 stop bit and no flow
control. Set the baud rate to 19200, to match that of the DHD Controller RS-232 port.
3. Press
<Enter>.
You should see a command prompt (>) in the terminal window.
4. Type a command from among those listed in Table 6-1 and press
<Enter>.
6.2
Serial Command
Syntax • Commands are in ASCII format and are not case-sensitive;
on
and
ON
are equivalent.
• For a command that takes no parameters, type the command followed by a carriage
return; for example, to turn on the system, type
ON <Enter>
.
• For a command that takes a parameter, type the command, one or more spaces and
the desired value followed by a carriage return; for example, to switch to the S-Video
input, type
SSRC 1 <Enter>
.
• When you enter a valid command, the DHD Controller executes it. When you send an
on/off, input selection, aspect ratio or image preset command, the DHD Controller also
responds with an acknowledgment on the command line. For example, when you issue
the command
SAR 2,
the DHD Controller responds with
Letterbox
on the
command line.
• When you enter a misspelled or otherwise invalid command, the DHD Controller
ignores it and responds with
Invalid Command
on the command line.
• When you send a command followed by values outside the valid range for that
command, the DHD Controller ignores it and responds with
Invalid Parameter
on the command line.
• When the DHD Controller receives an
OFF
command, it will not acknowledge or
execute any commands for approximately 90 seconds afterwards. This is to prevent
hot re-strikes of the lamp, which can damage it.
• After sending an
ON
command, allow at least 30 seconds for the projector and
controller to warm up before sending another command.
6. Serial Communications