RG-IS2700G Series Switch Hardware Installation and Reference Guide
4 System Debugging
4.1 Establishing the Configuration Environment
Establishing the Configuration Environment
Connect the PC to the console port of the switch through the console cable, as shown in Figure 4-1.
Figure 4-1 Schematic diagram of the configuration environment
4.1.1 Connecting the Console Cable
Step 1: Connect one end of the DB-9 jack of the console cable to the serial port of the PC.
Step 2: Connect one end of the console cable RJ45 to the console port of the switch.
4.1.2 Setting Terminal Parameters
Step 1: Start the PC and run the terminal simulation program on the PC, such as Terminal on Windows 3.1 or
HyperTerminal on Windows 95/98/NT/2000/XP.
Step 2:Set terminal parameters. The parameters are as follows: baud rate 9600, data bit 8, parity check none, stop bit 1,
and flow control as none.
Choose
Start
>
Programs
>
Accessories
>
Communications
>
Hyperterminal
. The hyperterminal window appears.
Choose
Cancel
, the interface as shown in Figure 4-2 is displayed.
Figure 4-2
