Hardware Installation and Reference Guide
Installing the Device
8
vertical distance be 0.5m, or the horizontal angle of the two bridges should be greater than 120 degrees. The installation
site can vary due to on-the-spot surveys conducted by technical personnel.
Please make full preparations as described in Chapter 2 and observe the following precautions before installing the device.
Before connecting the power supply, please use the PoE adapter shipped with the device or use a PoE adapter with
the same specification.
Before connecting the power cord, make sure the power switch is in the OFF position.
Make sure the power supply is properly connected.
3.4 Installing Device
Wall Mounting (connect the cable in advance)
1. Secure the mounting bracket on the wall.
2. Install the device to the mounting bracket.
Figure 3-1 Wall Mounting
Pole Mounting
1.
Secure the mounting bracket to the pole by threading a clamp through the mounting bracket.
2.
Install the device to the mounting bracket.
Figure 3-2 Pole Mounting
Assemble the mounting kit.
Adjust the orientation.
Drill
holes
into
the
marked
positions and insert wall anchors.
The head of the wall anchor should
be at least 10 mm above the wall
surface.
