Ruijie RG-EG Series Routers Hardware Installation and Reference Guide
Installing the Router
Guarantee the steadiness and good grounding of the workbench.
Attach the rubber pads onto the small holes at the bottom of the router, and maintain a minimum of 10 cm around the
device.
Do not place heavy things on the device.
3.3 Installing Power Cables
The requirements of Ruijie EG series router products on AC power supply are described below (refer to
Product Overview
for detailed parameters):
100
–240 V / 50/60 Hz.
RG-EG series router uses 3-conductor power cables. You are suggested to use a single-phase 3-conductor outlet or a
multifunction microcomputer outlet with neutral connector. The neutral point of the power supply shall be securely
grounded in the building. In most buildings, the neutral point of a power supply has been grounded during the construction.
You need to make sure the power supply is properly grounded.
Please take the following steps:
Plug one end of the power cable into the power socket on the backpanel of the router, and plug the other end into the
AC power supply outlet.
Check whether the power LED on the front panel of the router lights up or not. The LED indicator will light up if the
power supply is properly connected.
3.4 Checking after the Installation
After completing the mechanical installation of router, perform the following checks before powering on the device:
If the device is installed in a cabinet, check whether the angle bar for device installation is steady. If the device is
installed on the workbench, check whether sufficient room is reversed around the device to ensure heat elimination
and whether the workbench is steady.
Check whether the power supply meets the requirements.
Check whether the earth wire of device is properly connected.
Check whether the device is connected correctly to the configuration terminal.
