·
Note:
and
representing 1 RU delimiters
Before installing a guide rail, confirm that the weight capacity of the guide rail meets requirements.
Considering a variety of guide rails, guide rail appearance and installation methods depend on the actual
situation.
The RG-WALL1600-S3600 is heavy. To ensure cabinet stability: install the guide rail to as low a position as
possible in the cabinet if one RG-WALL1600-S3600 is installed; install heavier devices in the lower part of
the cabinet if multiple devices are installed.
Mounting into the Cabinet (Optional)
Precautions
Before mounting RG-WALL1600-S3600 into the cabinet, first verify that the front and back brackets of the cabinet are at
the right locations. If the bracket is too far forward, the front panel of the equipment may be too close to the front door, so
that the front door cannot be closed when network cables and pigtail fibers are connected. Allow at least 10 mm of
distance between the front panel of the equipment and that of the cabinet after installation. Before mounting into a cabinet,
you need to address the following conditions:
Fasten the cabinet.
Insert various modules in the frame properly.
Remove any obstacle in the frame and the surrounding environment.
Prepare the equipment and move it to the place near the cabinet where you can handle it easily.
Simple Installation Steps
1)
Levelly lift the RG-WALL1600-S3600 by two people on both sides, and slowly move it to the front of the cabinet.
2)
Levelly lift the RG-WALL1600-S3600 to a position slightly higher than the tray or the slide rail of the cabinet, put the
equipment onto the tray or the slide rail, and push it into the cabinet.
3)
Fasten the RG-WALL1600-S3600 onto the cabinet with screws. There are fastening notches on both the sides of the
front panel on the equipment frame. Use screws to fasten them to the fastening bracket of the cabinet. After fastened,
the equipment should be stable and still in the cabinet.
Connecting the AC Power Supply to the Power Module
Connect AC power cables according to the ID and position instruction on the AC power module.