RG-S7800C Switch Quick Installation Guide, V1.2
Installing the Switch
14
The RG-S7805C power system provides
two power supply slots. It is recommended that you configure
1+1
power supply
redundancy.
When RG-
S7808C
/RG-S7805C is powered up by more than one source, the power must be in the same model.
If you want to carry or lift the power module, please hold the bottom of the module with your hand instead of carrying the module
by the handle. Otherwise, the module may be damaged.
Before inserting or removing the power module, please verify whether the switch is well mounted. The switch is high, avoid switch
tumble when you are inserting or removing the power module.
If you want to hot swap a power supply, please make sure that the interval between two operation is greater than 30s.
Please do not touch the golden finger part of the power supply which is removed after power off in case that capacitor discharge
is not full.
Install the AC power system on RG-S7808C
1. Loosen the captive screws on the blank panel covering the power slot at the rear of the chassis.
2. Insert the power module into the slot along the rail until the rear connector of the power module stays in good contact with the rear
panel.
3. Tighten the captive screws on the power module to fix it.
Figure 4-12 Installing AC Power Supplies on RG-S7808C
Install the PoE power system
Take the same installation steps as the AC power installation.
Install the AC power system on RG-S7805C
1.
Loosen the captive screws on the blank panel covering the power slot at the rear of the chassis.
2. Insert the power module into the slot along the rail until the power module clicks into place.
Figure 4-13 Installing AC Power Supplies on RG-S7805C
