RuiDa RDC6445GT5, Руководство пользователя по оборудованию

Страница: 71 / 76

RDC6445GT5 Laser cutting system hardware user manualV1.1
深圳市睿达科技有限公司
63
achieved, and the high-power short-time light output mode will have a certain influence on
the life of the laser source. The system defaults to select the general mode.

。

Light spot size: when the general mode is selected as the scan mode, this parameter
is invalid; when the special mode is selected, this parameter is effective. The controller
controls the parameter between 50% and 99%.
The cutting and scanning process parameters cannot exceed the limit
parameter values in the axis parameters. If the axis parameter is exceeded, set
the process parameter as illegal, and the system will automatically overwrite
the process parameter with the axis parameter.
（
3
）
Reset parameters

Reset speed: X/Y axis linkage reset speed to the origin.

X axis power-on reset

Y axis power-on reset

Z axis power-on reset

U axis power-on reset
The parameter fields of the above four parameters are “Yes” or “No” optional, which are used
to configure whether each axis is reset when it is turned on.
（
4
）
Frame parameters

Frame mode: “Laser off and walk the frame” means idling, which can realize the
frame preview function; “Laser on and cut the frame” can manually cut the processed
graphics; “Four corners dots” means that laser is on at the four corners of the frame. mark a
dot, turn off the laser in other places, and you can visually check the size and position of the
graph through four points. The speed of frame is the speed value set on the keyboard when
the system is idle. Laser on, the minimum/maximum power of the laser is the corresponding
value set on the keyboard when the system is idle (the pulse power is when four-corners
dotting is the set maximum power value).
If over frame, there will be displayed on the interface. If user press the OK key
at this time, the system will use the maximum/minimum coordinates to cut off
the frame, and then perform the operation of frame. User can cancel this
frame operation.
When Preview /cutting a frame, whether to extend a certain length outside the actual frame of
the graph.
（
5
）
Other user parameters

Array processing method: two-way array and one-way array can be selected, which only works
for virtual arrays. Two-way array: cut the array back and forth in sequence; one-way array:
always cut the array from one direction to the other. When one-way array is selected, the
action mode of each array unit is exactly the same, and the movement fluency is completely
the same, but it takes a bit longer than two-way array. The two-way array is selected by
default.

Return position: positioning point and machine origin can be selected. This parameter
Prompt
Prompt