Cutting machine AR 10
5
!!! The operator must operate the machine according to the intended
use and strictly observe all points listed in the
“Operation”
work in-
structions prepared by the supervisor.
!!! Before putting the machine into operation for the first time and on
each working day, the operator must check the functionality of the
following safety devices:
a)
Visual check for changes or damages on all machine sides
and accessible machine parts, e.g. the cut-off knife, locking
mechanism of knife protection box. The machine must be
shut down in the event of any damage or changes!
b)
Check the safety switches as follows:
Install the grid frame and product stripper bar (ejection hood),
close the knife protection box, insert the slider and close the
chamber with it.
•
Start the machine.
–
Open knife protection box 20 mm
wide.
–
If the machine does not switched off, it must be
shut down immediately!
•
Start the machine.
–
Open the slider of the chamber 20 mm
wide.
–
If the machine does not switched off, it must be
shut down immediately!
•
Remove the grid frame.
–
Insert the slider.
–
Start the ma-
chine.
–
If it should start, it must be shut down immedi-
ately!
!!! To shut down the machine the main switch must be turned to
“0 –
OFF”
and the power plug pulled out of the socket! Secure the machine
against further use!
!!! The supervisor must arrange for the repair of the non-functional
safety device by a Rühle service technician. Until the corresponding
parts have been repaired, the supervisor must ensure that the ma-
chine or parts of the machine are not put into operation under any cir-
cumstances!
This applies also to leaking hydraulic systems!
