RuggedCom RuggedSwitch RSG2300, Руководство по установке

Страница: 13 / 52

RUGGEDCOM RSG2300
Installation Guide
Chapter 1
Introduction
Required Tools and Materials 3
Mode Color/State Description
Green (Solid) Link detected
Green (Blinking) Link activity
Status
Off No link detected
Green Full duplex mode
Orange Half duplex mode
Duplex
Off No link detected
Green (Solid) 100 Mbps
Green (Blinking) 1000 Mbps
Orange (Solid) 10 Mbps
Speed
Off No link detected
Display Mode Indicator LEDs The display mode indicator LEDs indicate the current display mode for the port status
indicator LEDs (i.e. Status, Duplex or Speed).
Mode Button The Mode button sets the display mode for the port status indicator LEDs (i.e. Status, Duplex
or Speed). It can also be used to reset the device if held for 5 seconds.
Alarm Indicator LED The alarm indicator LED illuminates when an alarm condition exists.
Power Module Indicator LEDs The power module indicator LEDs indicate the status of the power modules.
•
Green – The power supply is supplying power
• Red – Power supply failure
• Off – No power supply is installed
RS-232 Console Port The serial console port is for interfacing directly with the device and accessing initial
management functions. For information about connecting to the device via the serial
console port, refer to Section 3.1, “Connecting to the Device” .
Section 1.3
Required Tools and Materials
The following tools and materials are required to install the RUGGEDCOM RSG2300:
Tools/Materials Purpose
AC power cord (16 AWG) For connecting power to the device.
CAT-5 Ethernet cables For connecting the device to the network.
Flathead screwdriver For mounting the device to a DIN rail.
Phillips screwdriver For mounting the device to a panel.
4 x #8-32 screws For mounting the device to a panel.