Rugged Interactive
Unit 1, Callywith Court
Callywith Industrial Estate, Bodmin
Cornwall, UK
PL31 2RQ
+44 (0) 1726 981 123
www.rugged-interactive.co.uk
TrailBlazer
®
Traverse HEX
–
Section 3 - Installation
© Rugged Interactive
2019
3.4
–
Detailed Installation
Read this manual before installing the TrailBlazer Traverse HEX climbing wall.
Installation Guidelines:
▪
Please complete a
Site Survey
form prior to delivery and/or installation.
▪
Please send a completed
Installation Checklist
after any installation to Rugged Interactive.
▪
A typical installation should take 2 people about 4 hours.
▪
No obstructions or protrusions in the installation area: e.g. pipes, cables and wiring conduits.
▪
Avoid trapped and/or pinched cables.
▪
Use good practice when running data cables to and from products. Support long cables at least
every 50 cm and provide adequate strain relief for connection points.
▪
Power supply to be within 50 cm of the display box.
▪
To prevent electric shock, keep all electric components away from contact with water.
▪
IMPORTANT: Take anti-static precautions.
Structure:
▪
The ground area for installation will need to be flat and level. (Uneven ground surfaces make
alignment and fitting very difficult.)
▪
Ground area must be at least that of the TrailBlazer HEX footprint.
▪
TrailBlazer HEX can also be fitted around a pillar.
Fixings:
▪
The manufacturer will supply fixings (excluding floor angle brackets).
▪
All fixings must be tight and secure.
Required Tools and Consumables:
▪
A spirit level – to check floor is level before installation and that the TrailBlazer is level during
installation.
▪
An industrial vacuum cleaner.
▪
A dustpan and brush.
▪
A cordless drill – with torque adjuster to avoid over-tightening of screws.
▪
A set of No.2 Pozi bits.
▪
A small electrical-type flat-bladed screwdriver to unclip the CAT5 connectors from the grips.
▪
A stepladder
Suggested Extras:
▪
Cleaning cloth and gentle cleaning spray.
