Rugged CCTV SCOUT III, Инструкция по эксплуатации

Страница: 10 / 28

IR Dome Camera Instruction Manual
9
Chapter 4 Quick Start Operation Guide
4.1 Wiring Instruction
Caution: Do not turn the power ON until you have finished all connections and settings.
4.2 Setting protocol and baud rate.
(Turn the power off when setting, and restart the
device after revision)
The figure shows: Protocol: PELCO-D The figure shows: Auto detection protocol.
Baud rate: 2400 bps Baud rate: 2400bps
(Please refer to detailed parameter in next chapter)
This dip switch located on PCB in the dome device.
4.3 Camera installation (Please refer to camera installation section for more
details)
1. Make sure the correction of the ribbon cable between the camera module and the dome
core.
2. Different camera module may have different screws holes.
4.4. Connect the power to the dome
As soon as the power is turned ON, the dome initiates a self test which includes a rotation of
the dome on both axis and the camera will display a brief menu followed by a live image on the
monitor. The camera will display a blue screen.
Note:
During self-testing, it is normal to hear a clicking sound caused by the camera module for about 2-5
seconds of vertical movement, as a result of the vertical self alignment.
4.5 Joystick controller setting
Set the protocol, baud rate, and the address of the keyboard controller to match the settings of
the dome(For instructions of how to set the keyboard communication settings please refer to
keyboard controller manual).
GND(Yellow-Green)
Video Output
AC24V-(Black)
<<连续按 OPEN
选择 P：预置位,
T：花样轨迹，V：
矢量轨迹
AC24V+(Red)
GND(Yellow-Green)
RS485+ Orange
RS485- Yellow
Prot
oc
ol
s
e
tting
Baud
ra
te
s
et
ting
Prot
oc
o
l
s
e
tting
Baud
ra
te
s
et
ting