Rubi DT180EVO, Руководство оператора

Страница: 15 / 72

15 — English
ASSEMBLY
INSTALLING THE MITER GUIDE
See Figure 12.
The miter guide can be used from both the left and right side
of the cutting wheel.

Place the slot on the underside of the miter guide on the
sliding table fence.

Lock the miter guide securely to the table by turning the
lock knob clockwise.
To adjust angles:

Loosen the miter knob.

Rotate to the desired angle by moving the guide left or
right.

Tighten the knob securely before turning on the saw.
INSTALLING THE WATER PUMP
See Figures 13 - 14.
The pump recirculates water from the tray to the cutting
wheel.

The pump is equipped with suction feet to secure in place.
Press down firmly on the pump to attach the feet to the
bottom of the water tray.

Place the water pump’s electrical cord under the frame rails
and over the left side of the frame as shown in figure 14.

Push the end of the 90 ° fitting into the hole on top of the
water pump.

Connect the clear hose to the barbed end of the 90
°
fitting.

Position the pump as shown in Figure 13, with the hose
end of the fitting facing the rear of the tray.

Push back the rubber boot on the electrical cord and
plug the pump into the receptacle. Pull boot over cord
connections to help keep water off the plug.
Fig. 12
MITER
GUIDE
LOCK
KNOB
Fig. 13
SLOT
MITER
KNOB
RUBBER
BOOT
Fig. 14
90°
FITTING
CLEAR
HOSE
WATER
PUMP