Australia (Toll Free): 1800 352 228
International: +61 2 8853 3000
See our full range online at
www.rubbafix.com
6. Ensure the machine is on stable ground with the foot brake applied.
7. Turn Main Power 1 “ON”.
8. Set required temperature 15 (refer to Control Panel Settings for ideal temperatures for operating RubbaFIX
®
MELTA
®
Pro Applicator).
9. Allow time for machine to heat up and the RubbaFIX
®
pucks to melt (Time will vary depending on humidity,
environment, amount of product and application).
10. Ensure dispensing hose and gun are placed on the gun hook 11 when not being used.
11. When the ZONE temps meet the target ZONE temps, the system is up to temperature. Do not operate until this has
happened.
12. Turn the Pump Switch 8 “ON”.
13. The pump is activated by the trigger switch 11 which is located on the gun 9.
Note: Gas from moisture or air in lines, MAY cause splattering. It is recommend purging back Rubbafix
®
into tank to
clear out steam bubbles from hose.
14. The flow control 10 can be adjusted using the Hex key provided, (refer to section 5 for instructions of use).
15. Hold the nozzle approximately 5cm away from the repair area.
16. Aim the nozzle at the area where you want the product to be dispensed and squeeze the trigger (product will
continue to be dispensed as long as the trigger is squeezed).
17. When job is finished hang up gun, turn off machine and leave to cool down.
