6. CAUTION
7. WARNING
The RubbaFIX
®
MELTA
®
Pro can cause severe injury if incorrectly used. Those who use and maintain the system should
be trained on its proper use warned of its dangers and should read the entire manual before attempting to set up, operate
or adjust the machine.
• Do not squeeze the trigger switch on the gun when the system is cold.
• Do not adjust the Flow Control Knob when the system is cold.
• Do not allow the pump motor to stall. A prolonged stall will cause the motor to go into thermal overload.
• Do not connect or disconnect electrical connectors or remove components with the power on, This will prevent
arcing of electrical contacts and possible failure of components.
• Always close and secure the control panel access cover 13 to protect internal electrical components.
• Always operate the system with the tank lid Closed.
• Foot brake must always be on when machine is in use.
• Refer to RubbaFIX
®
Safety Data Sheet (SDS) for the following Warning instructions before using RubbaFIX
®
MELTA
®
Pro Applicator.
• RubbaFIX
®
Pty Ltd recommends an independent Risk Assessment should be carried out on this equipment before a
decision is made to use it underground.
• Working on or around the RubbaFIX
®
MELTA
®
Pro and equipment can cause severe burns.
• Use eye protection, Thermal gloves and protective clothing while operating.
• Before using any RubbaFIX
®
MELTA
®
Pro equipment, determine proper electrical requirements as per all applicable
codes.
• Ensure hazardous material(s) that are toxic, heat or fire sensitive are not located in the immediate vicinity of the
RubbaFIX
®
MELTA
®
Pro as fire, explosion, personal injury, property and/or equipment damage can result.
• The RubbaFIX
®
MELTA
®
Pro system is equipped with over temperature protection as a necessary safety device.
• Run-away heating can cause hot melt materials to exceed their flash point.
At RubbaFIX
®
Pty Ltd, we pay special attention to the needs of operators and service personnel when designing equipment,
but molten repair compounds are dangerous and can cause severe burns. Extreme care must be exercised to insure
personnel safety.
