3
© 06/2019 | Technical changes without notice | RTW GmbH & Co. KG | Am Wassermann 25 | 50829 Köln | Fon +49 221. 70 913-0 | Fax +49 221. 70 913-32 | [email protected] | www.rtw.com
Operation
If these preconditions are given and the TM-Dante is connected to the Dante network, you can start creating presets, defi ne
audio groups and assign input signals.
NOTE -
In each new created audio group of a preset, always the fi rst Dante input signals in the order will be assigned
to the channels for display. Therefore, please always verify the input routing and adjust the assignment if necessary.
Proceed as follows:
1. As described in the operating manual, open the menu system on your TouchMonitor and create a new preset.
Further information on how to create and manage presets can be found in the operating manual of your device.
2. Create a new
Audio Group
and defi ne the operation mode (e. g. 5.1).
AoIP-Dante
is set as
Domain
, this cannot be chan-
ged. Touch
Confi gure
in the
Input Routing
section to perform the input routing.
2.