RTS DKP 16 CLD, Руководство пользователя

Страница: 203 / 232

KP32CLD 193
Bosch Security Systems, Inc. User Manual F.01U.193.294 Rev. 10
Addresses and the RVON-2
Because the RVON-2 has an Ethernet interface, it is required to have a MAC (Media Access Control) Address. This is a low
level address that contains 48 bits. Do not confuse this address with an IP Address. In order to be IP compliant, all cards must
have a unique MAC ID when shipped from the manufacturer. Typically, the MAC Address of a piece of hardware, such as the
RVON-2 card, has a fixed or static address. Where as the RVON-2 card’s IP Address can change over time.
The MAC Address uniquely identifies each node of a network and interfaces directly with the network media. The RVON-2
card has a small 8-pin serial device on the board that the processor can read the unique MAC Address from. For more
information on MAC IDs, contact technical support.
NOTE: Each RVON-2 card needs to be programmed with its own IP Address.
Configure the RVON-2 from the KP CLD
The KP CLD firmware must be at version 2.1.6 or later to use the RVON-2 with the KP CLD.
Set the IP Address from the Service Level Menu
The RVON-2 card, when shipped has a default IP Address already configured, see “Default Addresses for the RVON Product
Line” on page 3. This must be changed in order for the RVON-2 card to function properly because the pre-configured IP
Address may not work with your network.
To set the IP Address , do the following:
1.
On the KP CLD, press Menu .

The top level menu appears .
2.
Using the 3 (

) or 6 (

), select Service .
3.
Press SEL .

The Service submenu appears .
4.
Using the 3 (

) or 6 (

), select RVON Setup .
5.
Press SEL .

The RVON-2 and RVON-IO appear in the display window.
6.
Using the 3 (

) or 6 (

), select RVON-2 .
7.
Press SEL .

IP Address, Gateway, and Netmask appear in the display window .
8.
Using the 3 (

) or 6 (

), select IP Address .
9.
Press SEL .

The current IP Address appears .
10.
Using the number pad, enter the first number in the IP Address.

This activates the first octet of the IP Address and clears the rest of the IP Address .
11.
Press SEL .

This confirms the first octet in the IP Address and moves you to the second octet .
NOTE: Press SEL to skip over any octet that does not need modification.
12.
Repeat steps 10 and 11 until the entire IP Address is entered.
13.
Press SEL .

IP Address, Gateway, and Netmask appear in the display window .
NOTE: Once you have entered the IP Address, enter the Gateway Address, if required. A Gateway is a node
(for example, a computer) on a network that serves as an entrance to another network.