Проверил: Р.Ч./24.03.2015г
- 12 -
Adjusting the angle of cutting (tilt of the heel of the circular saw), angle
cutting
You should loose the adjustment button located at the front of the instrument,
adjusting the heel of the circular at the desired angle and tighten the button. We
must remember that, when working at an angle there is a greater risk of the
phenomenon of weaning, that is why you should be careful and observe the
heel to lean on its entire surface on the processed material. The cutting should
be done smoothly.
Installation and setup of the cutting guide (parallel cutting)
The guide can be mounted at the left or right side of the appliance. In both
holes you should insert bar with graduated scale and you should tighten with a
button
Normal cutting
- While start working with one hand you should hold the handle and with the
other the appliance. No high-force should be applied, after cutting wait until the
saw blade stops completely. If the cutting has been accidentally stopped and
activated again, you must wait until the disc maximizes its revolutions to idling
speed.
Old electrical devices should not be treated as ordinary waste.
Disposal or recycling of parts of them should be in places with the
appropriate equipment. For information on collection and use of old
electrical equipment, contact your local authorities or dealer.
