rtd cpuModule CMC6686GX, Руководство пользователя

Страница: 109 / 118

108
Common Problems and Solutions
The following table lists some of the common problems you may encounter while using your cpu-
Module, and suggests possible solutions.
If you are having problems with your cpuModule, please review this table before contacting techni-
cal support.
Problem Cause Solution
cpuModule "will not boot" no power or wrong polarity check for correct power on PC/104 bus
connectors
incorrect Setup
(video disabled, etc.) reboot and press {Del} key to run Setup
defective or mis-connected de-
vice on bus check for misaligned bus connectors;
remove other cards from stack
cable connected backwards verify all cables are connected correctly
SSD installed backwards check for an SSD memory installed in
socket backwards
will not boot from particu-
lar drive or device device not bootable use sys command on drive or re-format the
device using the
/s switch
device not formatted format drive using /s switch
power not connected to boot
drive connect power cable to floppy or hard
drive
Atmel Flash shows disk
space available, but it can-
not be written part smaller than 1.44MB was
formatted as 1.44MB; it will
show space available even
when full ignore "disk space remaining" messages
from DOS
REMEMBER! A bootable disk contains 3
hidden files plus format info, totalling
about 150kB
will not boot from DiskOn-
Chip® DiskOnChip® is not the only
hard drive in system disable other hard drive(s) in system
using wrong DiskOnChip®
device (not 32 pin) change to correct (32 pin) DiskOnChip®
Boot device not set to Hard
disk run Setup and set boot device to Hard
Drive