Page 3 of 26
Manual Revision History
Rev A
New manual
Rev B
Added User Oscillator
Rev C (01/31/2008)
Added a section about supported baud rates.
Added a diagram of the User Oscillator.
Added information about COM port numbering in Windows.
Added section on COM port enumeration for application developers.
Rev D (08/13/2008)
- Added the IDAN-CM17320 Dimensions and Pinout section, which
replaces the (previously separate) IDAN Manual, IDM-650020032.
- Corrected the IDAN connector pinout, which was listed incorrectly
in IDM-650020032 rev A.
- Added information about RTD pre-installed User Oscillators
- Expanded the board block diagram to clarify the oscillator operation
- Renamed the jumper designations for the signal conditioning jumpers.
They now use the designations printed on the board silk, rather than the
JPxx designation from the schematic.
- Improved the Connector and Jumper Locations diagram.
- Changed the name of the RS-422/485 Transmitter control section to
more accurately indicate its purpose.
Rev E (8/17/2009)
- Added spec for External clock input
- Added second mode jumper to get RS-422 with drivers always enabled
and RS-485 with inverted RTS driver enable modes in addition to RS-
232 and RS-422/485 (now just RS-485 mode) with RTS driver enable
modes
Published by:
RTD Embedded Technologies, Inc.
103 Innovation Boulevard
State College, PA 16803
Copyright 2006 by RTD Embedded Technologies, Inc.
All rights reserved
The RTD Embedded Technologies Logo is a registered trademark of RTD Embedded
Technologies. dspModule, cpuModule, and utilityModule are trademarks of RTD Embedded
Technologies. PC/104, PC/104-
Plus
, and PCI-104 are registered trademarks of the PC/104
