Real Time Automation, Inc.
19
1-800-249-1612
7)
Enable 0-Based Addressing
: Check ONLY if the server you are connecting to begins their register
numbering at 0 OR they specify that their device addresses are 0-based.
8)
Bit Pack:
Select the formatting of the Coil Status/Input Status. Automap will use this packing size
to map coils to/from the other protocol. The bit pack selection here should match that of the
other protocol. The starting address is considered Bit 0 and is the low-order bit.
9)
To enable data swapping, select the required
Swap Indicator
. If the bytes appear in the wrong
order, enable swapping to change the data. This swapping does
NOT
change Coils and their
ordering inside the Bit Pack.
10)
Enter the number of Read Scan Lines and Write Scan Lines.
11)
Click the
Generate Scan Lines
button to have the read and write scan lines auto-generate for
you. You may manually configure the read and write scan lines after they have been generated.
