RSP TC20, Руководство по установке и обслуживанию

Страница: 17 / 20

M0119-1 version 3.1 17
4.3 Replacement of wear parts
4.3.1 Replacement of air sealings
4.3.2 Replacement of signal pins (electric versions only)
Replace a signal pin when worn or damaged.
Action Note
1 Remove air sealings Remove the air sealings with a screw
driver.
NOTE! There are totally 6 air sealings.
2 Clean sealing holes Wipe clean the sealing holes. Remove all
remaining parts of sealing and glue.
3 Replace air sealing Glue the new air sealing in the sealing
groove. Use a small amount of Loctite 480
(or similar). Press the sealing 60-120
seconds until the glue hardens.
Action Note
1 Power off Switch the power off and lock the circuit
breaker.
2 Remove signal pins Pull out the signal pins with a pair of pliers.
NOTE! There are totally 8 signal pins.
3 Replace signal pins
Fit the new signal pins by pushing them
into the sleeves.
NOTE! The signal pins should be fully
pressed into the sleeve using a small
screwdriver.
4 Power on Unlock the circuit breaker and switch the
power on.