32
Galaxy S+ CO
2
Incubator
User Guide
8
8
O
O
P
P
T
T
I
I
O
O
N
N
S
S
&
&
A
A
C
C
C
C
E
E
S
S
S
S
O
O
R
R
I
I
E
E
S
S
Most options must be factory-installed, while some may be retrofitted on-site by authorised
service personnel. Some combinations of options may not be possible, and some options
may incur extra cost: please inquire before ordering.
Option/ Accessory
RSB Order Code
Retrofitable
BMS Relay Contact Alarm
170-023P
Yes
High Temp Decontamination
170-219P
No
Access Port, 25mm
170-019P
No
Single Inner Glass Door
170-035P
Yes
Four Inner Glass Doors
170-022P
Yes
Eight Inner Glass Doors
170-025P
Yes
Left Opening Door (hinged at right)
170-216P
No
Viewing Door Option
170-037P
No
RS232 Port
170-220RP
Yes
Relay Contact for Remote Alarm
170-214P
Yes
Internal IP66 Mains Socket
170-224P
No
Below Bench Castor Set (two castors)
170-148P
Yes
Key Lock on Outer Door
170-233P
No
Copper Chamber
170-016P
No
8.1
BMS Relay Contact Alarm
The BMS (Building Management System) Relay Contact Alarm allows a signal from
a central alarm system to be switched ON or OFF to indicate an alarm condition at
the incubator.
The following alarms would activate the system: over-temperature, under-
temperature, system failure, CO
2
high and CO
2
low. The alarm is programmed to
indicate when there is a power failure or electrical fault (power surge or short circuit,
for example). The alarm may also respond to other alarm situations, according to
other options installed on the system.
The system connection is via a standard 6-pin DIN socket on the rear panel of the
incubator (
see Figure 9 for location & Figure 11 for detailed look
). The matching
plug is provided when the option is installed.
