M
ICRO
M
AG
-OP-EN
- 15 -
ONE PASS SCRUBBING (PAD ASSIST):
1. Turn on machine Power Switch
(A)
(if machine is
equipped with Optional Key Switch)
, make sure
the Speed Control Knob
(B)
is at a lower setting.
2. Lower the Squeegee by rotating the Squeegee Lift
Lever
(C)
all the way to the right. Turn on Vacuum
Motor with Vacuum Switch on Control Panel
(D)
.
3. Lower Scrubdeck head to the fl oor by
pressing the Scrubdeck Switch on the
Control Panel
(E)
(or by manually lowering
the Scrubdeck with Foot Pedal option)
.
4. Move the Solution Flow Lever
(F)
to
regulate the amount of solution fl ow.
5. Begin scrubbing by pressing the Scrubdeck switch
button
(F)
on the dash board or use
(optional)
green Drive Control Buttons. Adjust the Pad Assist
adjustment knob
(B)
to the desired setting.
6. Once the machine begins to move, check the
Down Pressure Gauge
(G)
(Optional)
. Start
scrubbing at the middle. Do not scrub in
the red, or the Circuit Breaker will blow.
7. To operate the machine in reverse, simply
pull the Reverse switch
(H)
back towards
the Handlebar. The reverse speed is set to
approximately 50% of the forward speed.
8. To stop the machine, shutoff Scrubdeck
switch
(F)
and Vac Motor
(D)
.
SCRUB ONLY:
1. Turn on machine Power Switch
(A)
while making sure
the Speed Control Knob
(B)
is at a lower setting.
2. Lower Scrubdeck head to the fl oor by pressing
the Scrubdeck Switch on the Control Panel
(E)
.
3. Move the Solution Control Lever
(F)
to
regulate the amount of solution fl ow.
4. Begin scrubbing by pressing one of the green
Drive Buttons
(G)
on the Handlebars. Adjust the
Speed Control Knob
(B)
to the desired setting.
5. To operate the machine in reverse, simply
pull the Reverse Switch
(H)
back towards
the Handlebar. The reverse speed is set to
approximately 50% of the forward speed.
6. To stop the machine, let go of the Drive Buttons
(G)
.
VACUUM ONLY:
1. Turn on machine Power Switch
(A)
while making sure
the Speed Control Knob
(B)
is at a lower setting.
2. Lower the Squeegee by rotating the Squeegee Lift
Lever
(C)
all the way to the right. Turn on Vacuum
Motor with Vacuum Switch on Control Panel
(D)
.
3. Begin vacuuming by pressing one of the green
Drive Buttons
(G)
on the Handlebars.
B
A
C
D
G
F
E