M
ICRO
M
AG
-OP-EN
- 11 -
ADJUSTING SQUEEGEE:
1.
Turning Adjustment Knob
(A)
clockwise
(tightening)
will lower tips and raise the center of the Squeegee
(SEE BELOW)
.
2. Adjustable
Wheel
(B)
(SEE ABOVE)
has 3 holes. The
closer to the machine the wheel is, the further from
the ground the wheel becomes. The farther from the
machine the wheel is, the closer to the ground the
wheel becomes.
3. This Squeegee is adjusted too far back and will not
pick up on the corners
(SEE BELOW)
.
NOTE: Tips off of the fl oor.
4. This Squeegee is adjusted too far forward and will not
pick up in the center
(SEE BELOW)
.
NOTE: Center spaced off the fl oor.
5. This Squeegee is adjusted just right with good
defl ection across the entire rear Blade
(SEE BELOW)
.
REMOVING SQUEEGEE:
1. With the Squeegee in the up position, turn machine
power off.
2. Disconnect
Vacuum
Hose
(A)
from Squeegee and
loosen both knobs
(B)
(SEE BELOW)
.
3. Pull Squeegee assembly backward from the lifting
carrier.
4. Inspect or repair as needed and reinstall.
REPLACING OR ROTATING SQUEEGEE BLADES:
FOR SAFETY: Before leaving or servicing the machine,
stop on a level surface, turn off machine and remove key.
1. Remove the Squeegee Assembly from the machine.
Remove Blade Retainer Strap and remove Squeegee
Blade.
2. Rotate the Squeegee to new edge position or replace
as required.
3. Install Blade on the locating pins of Squeegee
Assembly.
4. Install Squeegee Retainer Strap.
5. Fasten and lock knobs, starting in the center and
moving outwards.
A
B
B
B
A
