37
When the filtration is turned off during a long time, a high level of chlorine, and an excessive mixture of
chemical products or after extreme weather conditions, the water of your pool can turn green, brown or
even black. In this case, you may act immediately.
GREEN WATER TREATMENT
If you choose to stop the filtration and winterizing to the pool, you must have a winter cover.
Ask some advice to your supplier.
After a complete cleaning of your pool (vacuuming, cleaning the skimfilter, cleaning the water line
surface, etc) and have proceeded to an intensive treatment of the water, you may put inside the pool a
winterizing product and start the system filtration for one hour until the product is totally dissolved,
then:
HIBERNATION OF THE POOL
When the good days come back, you can restart the pool.
Remove the winter cover and wash it. Before the storage, dry it and then pack it.
Clean the coping and the water line surface.
Then adjust the level of the water.
If necessary, use the vacuum cleaner and brush carefully the walls and the bottom of the pool.
Then, follow the instructions in chapter “Green water treatment”
Your pool is now ready to be used and to give you unforgettable moments in family.
RESTART AFTER THE WINTERIZING
SPECIAL CASES
1. First, make a Ph and a chlorine analysis
2. Filtration must work continuously over 24h until the water become transparent
3. Readjust the PH and the chlorine
4. Make an intensive treatment of chlorine according to the advices of the producer
5. To facilitate the process of algae elimination, put inside the skimfilter a tablet of
FLOVIL floculant.
6. Once a day at least, clean the cartridge filter until the water becomes transparent
7. Once the water recovers the normal state, follow the given advice.
8. Check chlorine and PH levels once a week. If it necessary, increase or decrease the
filtration according to the water temperature.
1. Decrease the level of the water until 30 cm below the skimfilter
2. Drain hoses, tubes of the skimilter and the outlet nozzle
3. Take the cartridge out of the skimfilter and screwed a Gizzmo
4. Place a stopper in the outlet nozzle
5. Turn off the power of the pump
6. Drain the pre-filter of the pump and keep it in a dry room
7. Install floaters in the diagonal of the pool
8. Take out the stainless steel ladder
9. Put the cover on the pool
10. Put the peripherical stretcher inside the eyelets
11. Fixt he stretcher in the hooks situated under the coping.
We recommend the placing of a buoy under the cover to avoid that the rainwater accumulates in the pool.
