30
The flip-up mechanisms and springs can
be replaced if needed. Using a small screw
driver, remove the three screws that hold in
the mechanism being careful to not strip the
plastic they are threaded into.
Carefully align the replacement spring and
the flip-up mechanism onto the pegs in the
Welding Visor. Insert and screw in the 3
replacement screws to attach the spring and
mechanism without over tightening.
REPLACING THE WELDING VISOR FLIP-UP MECHANISM
Position the spring onto the new flip up
mechanism and secure it with the screw
provided.
When welding, be sure to install a RPB
®
Zytec face seal or shoulder cape for adequate
protection from sparks, debris, and light
flashes. If using a face seal, make sure all
skin, such as the neck, is covered to prevent
UV radiation and burns. Follow the cape
installation instructions on page 23.
WELDING SHOULDER CAPE
FIGURE 16.1
FIGURE 16.2
FIGURE 16.3
FIGURE 17.1
SETUP AND CARE -
Z-LINK+
®
WELDING CONFIGURATION
CONTINUED
