OPERATING INSTRUCTIONS FOR SS2-KNOB CONTROLLER
TO COOK USING TIMER:
1,) POWER SWITCH ON.
2.) SET COOK TEMP. (KNOB)
3.) SET HOLD TIME. (KNOB)
4.) ALARM SOUNDS WHEN PRE-HEATED (PRESS CLEAR ALARM).
5.) LOAD OVEN WITH PRODUCT.
6.) SET COOK TIME
7.) PRESS START.
TO COOK USING PROBE:
1.) POWER SWITCH ON .
2.) SET COOK TEMP. (KNOB)
3.) SET HOLD TEMP. (KNOB)
4.) ALARM SOUNDS WHEN PRE-HEATED (PREES CLEAR ALARM).
5.) PLUG IN PROBE.
6.) SET COOK-TO TEMPERATURE
7.) LOAD PRODUCT AND INSERT PROBE.
8.) PRESS START.
Note: With the completion of the cook-probe/rethermalizing cycle, the oven will
automatically go into the hold cycle and the clock will start to register the
amount of time your product has been holding..
*VERY IMPORTANT*
Never taker refrigerated or frozen product and try to rethermalize while the oven
is in the hold cycle.
ERROR CODES
:
'E-1 indicates an RTD malfunction - to repair, replace RTD.
"E-2" indicates parameter data recorded in programming mode may be corrupted
- power down unplug ( about 1 minute) plug back in, power up.
"E-3' indicates the logged data after a power failure was not logged properly -
same as above.
998
1
Yo
r
k
-
Th
e
t
a
D
r
iv
e,
N
o
r
th R
oy
a
lt
o
n
,
O
hio
441
33
44
0-
237
-
08
06 F
AX:
4
40
-
237
-
16
9
4 1
-
80
0
-
66
2-
8765
