11
•
Open the door, and Take down the lid of cylinder cargo carefully and put it in the center of the tank bracket
(See the picture 6-7)
•
Locate the hose out of the pathways where people may trip over it or in areas where the hose may be subjected
to accidental damage.
CAUTION:
Do not kink flexible gas hose. If it is kinked, a gas leak could occur
Instruction for connecting gas circuit to LPG cylinder:
Keep at hand suitable crossed screwdriver, adjustable spanners, pliers and wrenches. Before assembly, make sure
all protection packing material has been removed. Flexible gas rubber pipe (EN 1763-1) and clamps (if necessary)
are supplied with this appliance and must be used, according to National Rules in force. You need to purchase one
gas regulator and one gas cylinder. The gas regulator has to be set according to specific gas category (see on page
2) and proper gas consumption (g/h) specification. The LPG cylinder should be standard one. Recommend to use
4.5kg to 15 kg one. Replacement must be that specified in “Gas Requirements” section of this Instruction Manual.
Be careful: do not kink flexible gas rubber pipe of gas circuit.
If pipe holder should not be provided, thread of the
gas inlet connection will be in line with Standards ISO 7-1 or ISO 228-1, according to National Rules in force of the
country of destination.
•
Make sure appliance gas knob is turned "OFF" (full disk) before assembling (see below Figure5).
•
Put the LPG cylinder inside of the tank bracket, and tight the screw (see below Figure6-8)
(Picture 5) (Picture 6) (Picture 7)
•
Connect the regulator to LPG cylinder by hand. And Hand tighten only. (see below Figure8)
(Picture 8)
