RWD-500W
7
• If there is any water left in the tanks you must open the drain plug located on the back right hand side, until it drains completely
• Finish by closing the drain cap
Now that the water cooler has been setup there are only a few more steps required to get the water cooler ready for use.
1. Remove the cap from the 5-gallon bottle and use a clean cloth to wipe off the neck of the bottle.
2. Place the 5-gallon bottle of water on the water intake; allow water to stand for approximately one minute.
3. Push water faucet buttons to insure water flows from both faucets.
4. Plug dispenser back into the electrical outlet.
5. Now you are ready to use your water dispenser.
Operating the Water Cooler
On the front panel, near the bottom there are two different coloured buttons, one being red and the other being blue. These are the two buttons
that will disperse the water. The blue button disperses cold water, while the red disperses hot water. The difference between the two buttons is that
the red hot water button has a child safety feature.
Safety Feature – Child Lock
The Water Dispense comes with a child safety lock for the hot water dispenser to help prevent children from burning themselves by accidentally
pressing the hot water button. For users who wish to get hot water from the dispenser they must follow these steps:
• Slide red safety button (Shown left) to the right and hold
while pressing downward on hot water faucet to dispense
hot water
• Safety button will return to its original position when faucet
is released
