RWD-500W
11
TROUBLESHOOTING
Problem
Possible Cause
Water dispenser does not operate.
Unit not plugged in.
The circuit breaker tripped or a blown fuse.
Water cooler is not cold enough.
Check to be sure the cold switch on the back is ON.
The water dispenser does not have the correct clearances.
Water dispenser hot water is not hot enough.
Check to be sure the hot switch on the back is ON.
Compressor turns on and off frequently.
The room temperature is hotter than normal.
The temperature control is not set correctly.
The water dispenser does not have the correct clearances.
Vibrations.
Check to assure that the water dispenser is level.
The water dispenser seems to make too much noise.
The rattling noise may come from the flow of the refrigerant, which is normal. As each cycle
ends, you may hear gurgling sounds caused by the flow of refrigerant in your water dispenser.
Contraction and expansion of the inside walls may cause popping and crackling noises. The
water dispenser is not level.
Bottle feels warm.
The water system is overfilled. Dispense Cold water until air is released into the bottle.
Water bottle is hot.
Water is boiling in the hot tank and bubbling up into the bottle. Press the hot dispenser button
until water flows to remove air from the hot tank.
Additional Problems
If you were unable to fix your problem after consulting the troubleshooting section then you should call a technician to resolve the issue
WIRING DIAGRAM
Included is the Wiring Diagram of the WATER DISPENSER
L
E
N
