●
Fan speed button
Press the “ ” button to select the fan speed to high and low. Note: “ ”symbol on, means the unit is set to high speed setting.
●
Timer button
This timer can be used to delay the unit start-up or shutdown. This avoids wasting electricity by optimising operating periods.
●
Programming start-up
- Press the “ ” button. The screen starts to flash. Press the “ ” / “ ” to adjust the set time from 0.5-24 hours.
- Wait for 5 seconds. The “ ”symbol turns ON. Programming is now set.
- To cancel, press “ ” button. The “ ”symbol disappears.
●
Programming shut down
- When the unit is running, press the “ ” button. The screen starts to flash. Press the “ ” / “ ” to adjust the set time from 0.5-24 hours.
- In 5 seconds without the operation, the timer start function, then the “ ” symbol turns ON. Programming is now set.
- To cancel, press the “ ” button. The “ ” symbol disappears.
●
Bucket Full Alarm
- When the bucket is full, the compressor will shut off and the fan will stop for a few minutes. A 'beep' will sound to indicate that the bucket needs to be
emptied. The “ ” symbol will flash.
Important Note:
(1) The unit will not run again until the bucket is emptied and properly placed back inside the unit.
(2) The bucket should be cleaned every week to prevent the growth of mold, mildew and bacteria. Use a mild detergent to clean. Once clean, completely dry the
bucket and place it back inside unit.
9
The bucket
with handle
Important Note
1. Hold the bucket with both hands when emptying.
2. When the bucket is full or removed from the unit, the compressor will turn off but the fan will
continue to run for a few minutes. This is completely normal. The unit will not be removing
moisture from the air at this time.
3. During operation, it is normal for the unit to exhaust warm air from the top of the unit.
Caution: Do not place the bucket on the floor when it is full as it is uneven on the
bottom and water may spill.
