4. Door fitting
Open the hinge flat and position it on the left side of the door as show, secure in place using 9 x 25mm screws. Position the door in the door way, adjust the height of the
door so it will be able to open and close freely. When in place secure hinge to the door frame using 9 x 25mm screws.
25mm
25mm
Door
Door
Gap
No gap
Important
When fitting the hinge ensure there is
no gap between the front of the door
and the hinge bar.
5. Securing the walls to the floor
Ensure the walls are sitting square on the floor and secure them down using 16 x 50mm screws, screw through the panel framing into the floor.
50mm
50mm
Back panel
Side panel
50mm
50mm
Create two left and two
right-handed panels.
Important
Front apex
Rear apex
Roof panels
Bargeboard blocks at the back
of the building must be butted
up against the outside of the
rear apex panel.
Side view of roof position
35mm
50mm
50mm
440mm
440mm
Felt
batten
Felt
batten
35mm
35mm
6. Roof
Secure a felt batten to the lower edge of each roof panel using 5 x 35mm nails per batten as shown. Ensure the felt battens are flush to the edges of the panels. Flush to
the front edges of each panel attach three bargeboard blocks using 2 x 35mm nails per block, see diagram below for correct spacing of the blocks. Create two left and
two right-handed panels. Position two panels on top of the building with the bargeboard blocks overhanging the rear of the building, make sure the top edges of the panels
are located at the apex and bargeboard blocks are butted up against the apex panel. Secure each panel in place using 8 x 35mm nails. Position the two remaining roof
panels on top of the building with the bargeboard blocks over hanging the front edge of the building. Ensure the front two roof panels are butted up next to the two rear
roof panels and secure in place using 8 x 35mm nails per panel.
400mm
400mm
Left-hand panel
Right-hand panel
Bargeboard block spacing
