WiFly Serial Adapter
www.rovingnetworks.com
wifly-serial-um 6/30/2010
809 University Avenue
•
Los Gatos, CA 95032
•
Tel (408) 395-6539
•
~ 13 ~
•
Enable adhoc mode by turning on switch 1, power on the WiFly Serial adapter.
•
Associate to the Adhoc network from your computer. Use ping to verify the WiFly serial adapter is
visible on the network.
•
Start TeraTerm and select the TCP/IP radio button. You will need to set the IP address of the module
which will be 169.254.1.1. Also select the Telnet radio button and set the port to 2000. Hit OK
•
The module will reply with the string
*HELLO*
indicating that the connection has been
established.
3.3.
Getting into command mode
Type $$$ (3 dollar signs) into the terminal emulator or telnet window, you should see
CMD
returned to
you. If you see
CMD
you know that your connection and terminal settings are correct.
Entering <CR> command returns a prompt <x.xx> where x.xx is the version number of the firmware
running. Invalid syntax returns
ERR: ?-Cmd
, and incorrectly formatted commands return
ERR: Bad
Args
or
ERR: 2few Args
To exit command mode type
exit
. You will see EXIT echoed to indicate the module is in data mode.
